Halogen Heat Lamp 490mm 950w for Flash Cure Drying Machines

Sat, 11 Jul 2026 01:33:56 +0800

Getting Flash Curing Right with the 490mm 950W Halogen Lamp

When you’re flash curing, you don’t have time to mess around. You need a massive spike of heat right now to set your inks or coatings, but you have to do it without melting the actual part you’re working on. That’s exactly why we built this 490mm 950W lamp. It’s all about the heat hit. At 950W over a 490mm stretch, this thing is built for speed. We use a halogen cycle to keep the tungsten filament from evaporating and gunking up the quartz tube. Why does that matter? Because it keeps the glass clear. When the tube stays clear, the IR output stays steady for the long haul. It ramps up fast—which is a lifesaver when your parts are flying down a conveyor and only spend a few seconds under the heat. Fitting it into your setup If you’ve got a mid-sized flash cure machine, the 490mm size is pretty standard. These are meant to be simple drop-in replacements. No fuss. We use high-purity quartz glass so the lamp doesn’t crack under the intense heat, and the electrical terminals are beefy enough to handle the current without pitting or wearing out. One quick tip:**keep your reflectors clean.**Seriously. A dusty reflector kills the efficiency of a 950W tube and puts a lot of unnecessary stress on your power supply. A few things to watch out for These lamps shine in high-speed lines. They put out intense short-wave radiation, so the heat sinks into the surface layer almost instantly. But here’s the thing… 950W in one spot creates a lot of ambient heat. If your ventilation is a bit weak, you might end up burning out your sockets or frying nearby electronics. To keep things safe, wire it up to a precise PID controller. It’ll stop you from overshooting your temp and scorching your product. Nobody wants a batch of burnt parts.

950w on Thermal Ray Lamp

Halogen Heat Lamp 490mm 950w for Flash Cure Drying Machines

Getting Flash Curing Right with the 490mm 950W Halogen Lamp