A Real-World Look at our 320mm 500W Halogen IR Lamps
If you need heat—and you need it now—these lamps are your best bet. We built these specifically for those situations where you can’t afford to wait for a slow warm-up and you need the heat concentrated exactly where it hits. Here is the secret sauce: we put a halogen gas cycle inside the quartz tube. In a normal lightbulb, the filament just evaporates and the glass gets all cloudy and gross. Not here. The halogen keeps the glass crystal clear and stops the filament from burning out nearly as fast. It just lasts longer. Simple as that. The size and the power At 320mm long and pulling 500W, these fit right into most industrial drying tunnels or PET blowing machines without any fuss. You get a steady, reliable stream of heat across your surface. But a quick heads-up: get your reflectors aligned. If they’re off, or if you put the lamp too close to your part, you’re going to get hot spots. And nobody wants to accidentally melt their workpiece. What’s under the hood? We use quartz because it doesn’t warp when things get screaming hot. Because of that halogen gas I mentioned, we can push the filament to higher temperatures, which gives you that punchy, short-wave IR emission. Swapping them out is a breeze, too. They use standard push-in connectors. You can pull a dead one and pop a new one in within a few minutes. No headache, no long downtime. Putting them to work Whether you’re curing, drying, or shaping plastic, these things are fast. Way faster than waiting for hot air to circulate. It just cuts your cycle times down. Just remember: 500W puts out a lot of heat. Make sure your housing is built for it and your cooling fans are actually doing their job. If you don’t vent the enclosure, the heat just builds up inside and fries your electrical terminals. Give the lamp some room to breathe, and it’ll take care of you.